| Last Modified: 11-29-2007 | 1.6 J | |
| Service Category: Audio/Visual/Telematics | Section: Navigation/Multi Info Display | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM00000183G02EX |
| Title: NAVIGATION / MULTI INFO DISPLAY: NAVIGATION SYSTEM: INSPECTION PROCEDURE (2008 Sequoia) | ||
|
Navigation Receiver Assembly Communication Error |
INSPECTION PROCEDURE
PROCEDURE
|
1. |
IDENTIFY COMPONENT SHOWN BY SUB-CODE |
|
(a) Enter the diagnostic mode. |
(b) Press the "LAN Mon" switch to change to "LAN Monitor" mode.
(c) Identify the component shown by the sub-code.
HINT:
- "140 (navigation receiver)" is the component shown by the sub-code in the example shown in the illustration.
- The sub-code will be indicated by its physical address.
-
For the component list, refer to "Diagnosis Display Detailed Description"
.
|
|
2. |
CHECK POWER SOURCE CIRCUIT OF COMPONENT SHOWN BY SUB-CODE |
(a) Inspect the power source circuit of the component shown by the sub-code.
Component Table
|
Component |
Proceed to |
|---|---|
|
Stereo component amplifier (440) |
Stereo Component Amplifier Power Source Circuit
|
|
Television display (1B0)* |
Television Display Power Source Circuit
|
HINT:
- *: w/ Rear Seat Entertainment System
- If the power source circuit is operating normally, proceed to the next step.
|
|
3. |
INSPECT NAVIGATION RECEIVER ASSEMBLY |
|
(a) Disconnect the I20 and I8* navigation receiver assembly connectors. HINT:
*: w/ Rear Seat Entertainment System |
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection |
Condition |
Specified Condition |
|---|---|---|
|
I20-5 (ATX+) - I20-15 (ATX-) |
Always |
60 to 80 Ω |
|
I8-9 (TXM+) - I8-10 (TXM-)* |
HINT:
*: w/ Rear Seat Entertainment System
(c) Reconnect the navigation receiver assembly connectors.
|
|
4. |
CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - COMPONENT SHOWN BY SUB-CODE) |
HINT:
- Start the check from the circuit that is near the component shown by the sub-code first.
-
For details of the connectors, refer to "Terminals of ECU"
.
(a) Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the navigation receiver assembly and the component shown by the sub-code.
(1) Disconnect all connectors between the navigation receiver assembly and the component shown by sub-code.
(2) Check for an open or short in the AVC-LAN circuit between the navigation receiver assembly and the component shown by the sub-code.
OK:
There is no open or short circuit.
|
|
5. |
REPLACE COMPONENT SHOWN BY SUB-CODE |
(a) Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.
OK:
Same problem does not occur.
|
|
|